0

Plug and 3D-Print With the Makerbot Replicator 2016,2017

Posted by Mohammad Ajmal on 11:21 AM

Plug and 3D-Print With the Makerbot Replicator 2016,2017



3D printers have always appealed to makers and tinkerers who don't mind (and probably enjoy) building and troubleshooting their gadgets. But the average consumer has high out-of-the-box expectations for tech products. They want to plug it in, turn it on, and start working—something that has been a challenge for generations of 3D printers that can best be described as "finicky." From what we've observed, the Replicator+ should appeal to users of all technical skill levels and will satisfy more than frustrate 3D printing enthusiasts.






The Replicator+ is a bit larger than a microwave oven at 20.8 x 17.4 x 16.2 inches. It weighs about 40 pounds, so it takes a bit of effort to lift it onto a table, but it can be done by one person...


0 Comments

Post a Comment

Copyright © 2009 Latest Electronic Products All rights reserved. Theme by Laptop Geek. | Bloggerized by FalconHive.